2010 Jeep Commander Owner's Manual - Page 370
2010 Jeep Commander Manual
Page 370 highlights
370 MAINTAINING YOUR VEHICLE Operation of the wipers on dry glass for long periods windshield will light on the vehicle graphic outline and may cause deterioration of the wiper blades. Always use the "WASHER FLUID LOW" message will be displayed. washer fluid when using the wipers to remove salt or dirt The fluid reservoir for the windshield washers and the from a dry windshield. rear window washer is shared. The fluid reservoir is Avoid using the wiper blades to wipe frost or ice from the located in the engine compartment, be sure to check the windshield. Keep the blade rubber out of contact with fluid level at regular intervals. Fill the reservoir with windshield washer solvent only (not radiator antifreeze). petroleum products such as engine oil, gasoline, etc. When refilling the washer fluid reservoir, take some NOTE: Life expectancy of wiper blades varies dependwasher fluid and apply it to a cloth or towel and wipe ing on geographical area and frequency of use. Poor clean the wiper blades, this will help blade performance. performance of blades may be present with chattering, To prevent freeze-up of your windshield washer system marks, water lines or wet spots. If any condition is in cold weather, select a solution or mixture that meets or present please proceed to clean wiper blades with humid exceeds the temperature range of your climate. This cloth removing any debris that may be affecting its rating information can be found on most washer fluid function. containers. Adding Washer Fluid On vehicles equipped with a Electronic Vehicle Information Center (EVIC), the low washer fluid level will be indicated. When the sensor detects a low fluid level, the