2010 Jeep Commander Owner's Manual - Page 121
2010 Jeep Commander Manual
Page 121 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 121 To Deactivate A soft tap on the brake pedal, pulling the Electronic Speed Control lever toward you, or normal brake pressure while slowing the vehicle will deactivate Electronic Speed Control without erasing the set speed memory. Pressing the ON/OFF button or turning off the ignition switch erases the set speed memory. Control lever is tapped, speed increases so that tapping the Electronic Speed Control lever three times will increase speed by 3 mph (5 km/h). To decrease speed while Electronic Speed Control is ON, push down and hold SET DECEL. Release the Electronic Speed Control lever when the desired speed is reached, and the new speed will be set. 3 To Resume Speed Tapping the SET DECEL lever once will result in a 1 mph To resume a previously set speed, push the RESUME (2 km/h) speed decrease. Each time the lever is tapped, ACCEL lever up and release. Resume can be used at any speed decreases. speed above 20 mph (32 km/h). To Accelerate for Passing To Vary the Speed Setting Depress the accelerator as you would normally. When the When the Electronic Speed Control is ON, speed can be pedal is released, the vehicle will return to the set speed. increased by pushing up and holding RESUME ACCEL. Release the Electronic Speed Control lever when the Using Electronic Speed Control On Hills desired speed is reached, and the new speed will be set. The automatic transmission may downshift on hills to maintain the vehicle set speed. Tapping RESUME ACCEL once will result in a 1 mph (2 km/h) speed increase. Each time the Electronic Speed