2010 Jeep Commander Owner's Manual - Page 134
2010 Jeep Commander Manual
Page 134 highlights
134 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 6. Firmly press and release the "LEARN" or "TRAIN- Gate Operator/Canadian Programming ING" button. The name and color of the button may vary Canadian radio-frequency laws require transmitter signals to "time-out" (or quit) after several seconds of by manufacturer. transmission - which may not be long enough for NOTE: There are 30 seconds in which to initiate the next HomeLink to pick up the signal during programming. step after the "Learn" button has been pressed. Similar to this Canadian law, some U.S. gate operators are 7. Return to the vehicle and press the programmed designed to "time-out" in the same manner. HomeLink button twice (holding the button for two It may be helpful to unplug the device during the cycling seconds each time). If the device is plugged in and process to prevent possible overheating of the garage activates, programming is complete. door or gate motor. If the device does not activate, press the button a third If you are having difficulties programming a garage door opener or a gate operator, replace "Programming time (for two seconds) to complete the training. HomeLink" Step 3 with the following: If you have any problems or require assistance, please call toll-free 1-800-355-3515 or, on the Internet at 3. Continue to press and hold the HomeLink button while you press and release - every two seconds www.HomeLink.com for information or assistance. ("cycle") your hand-held transmitter until HomeLink To program the remaining two HomeLink buttons, has successfully accepted the frequency signal. The repeat each step for each remaining button. DO NOT EVIC display will change from "CHANNEL # TRAINerase the channels. ING" to "CHANNEL # TRAINED."