2010 Jeep Commander Owner's Manual - Page 135
2010 Jeep Commander Manual
Page 135 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 135 If you unplugged the device for training, plug it back in 2. Press and hold the desired HomeLink button for 20 seconds until the EVIC display states "CHANNEL # at this time. TRAINING." Do not release the button. Then proceed with Step 4 under "Programming 3. Without releasing the button, proceed with ProgramHomeLink " earlier in this section. ming HomeLink Step 2 and follow all remaining steps. Using HomeLink To operate, simply press and release the programmed Security HomeLink button. Activation will now occur for the It is advised to erase all channels before you sell or turn trained device (i.e., garage door opener, gate operator, in your vehicle. security system, entry door lock, home/office lighting, To do this, press and hold the two outside buttons for etc.) The hand-held transmitter of the device may also be 20 seconds until the EVIC message states "CHANNELS used at any time. CLEARED." Note that all channels will be erased. IndiReprogramming A Single HomeLink Button vidual channels cannot be erased. To reprogram a channel that has been previously trained, The HomeLink Universal Transceiver is disabled when follow these steps: the Vehicle Security Alarm is active. 1. Turn the ignition switch to the ON/RUN position. 3