Brother International Innov-ís 950D Users Manual - English - Page 111
pocket faces toward you, and then lower
View all Brother International Innov-ís 950D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
Determine the desired length of the bar tack. a Set the button guide plate on buttonhole foot "A" to the desired length. (The distance between the markings on the presser foot scale is 5 mm (3/16 inch).) 1 • Pass the upper thread down through the hole in the presser foot. 2 3 a Presser foot scale b Length of bar tack c 5 mm (3/16 inch) Memo z A bar tack with a maximum length of about 28 mm (1-1/8 inches) can be sewn. Note z When lowering the presser foot, do not push in the front of the presser foot, otherwise the bar tack will not be sewn with the correct size. 3 Attach buttonhole foot "A". b • For details on replacing the presser foot, refer to "Replacing the presser foot" (page 43). Select stitch 60 . c • For details, refer to "Selecting stitching" (page 51). a a Do not reduce the gap. Pull down the buttonhole lever as far as e possible. Position the fabric so that the opening of the d pocket faces toward you, and then lower the presser foot lever so that the needle drops 2 mm (1/16 inch) in front of the pocket opening. 1 a 2mm (1/16 inch) a a Buttonhole lever The buttonhole lever is positioned behind the bracket on the buttonhole foot. a b a Buttonhole lever b Bracket Reinforcement Stitching 109