Brother International Innov-ís 950D Users Manual - English - Page 71

■ If thick seams are being sewn and the fabric does not feed at the beginning of stitching The fabric may not feed when thick seams are being sewn and the presser foot is not level, as shown below. In this case, use the presser foot locking pin (black button on the left side of zigzag foot "J") so that the presser foot remains level CAUTION z If fabric more than 6 mm (15/64 inch) thick is sewn or if the fabric is pushed with too much force, the needle may bend or break. while sewing, allowing the fabric to be fed smoothly. Sewing hook-and-loop fastener 2 a a Sewing direction Raise the presser foot lever. a Align the beginning of stitching, and then b position the fabric. While holding zigzag foot "J" level, hold the c presser foot locking pin (black button on the left side) pressed in, and lower the presser foot lever. CAUTION z Use only the ungummed hook-and-loop fastener designed for sewing. If the glue adheres to the needle or the bobbin hook race, it may cause malfunction. z If the hook-and-loop fastener is sewn with a fine needle (65/9-75/11), the needle may bend or break. Note z Before starting to sew, baste the fabric and hook-and-loop together. a a Presser foot locking pin (black button) Release the presser foot locking pin (black d button). X The presser foot remains level, allowing the fabric to be fed. Make sure that the needle passes through the hookand-loop fastener by turning the handwheel and lower the needle into the hook-and-loop fastener before sewing. And then, sew the edge of the hookand-loop fastener at a slow speed. If the needle does not pass through the hook-andloop fastener, replace the needle with the needle for thick fabrics (page 39). a a Edge of the hook-and-loop fastener • After the seam is sewn, the presser foot will return to its original angle. Useful Sewing Tips 69