Brother International Innov-ís 950D Users Manual - English - Page 92
the fabric.
View all Brother International Innov-ís 950D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
UTILITY STITCHES Note z Do not lower the needle into fabric when aligning the marks. Desired results may not be achieved. z When lowering the presser foot, do not push in the front of the presser foot. Press (Thread cutter button) once. h a a Thread cutter button X The threads are cut and the needle is raised. Raise the presser foot lever, and then remove i the fabric. a a Do not reduce the gap. Pull down the buttonhole lever as far as f possible. a a Buttonhole lever The buttonhole lever is positioned behind the bracket on the buttonhole foot. a Memo z If programmed thread-cutting is set, the sewing machine will sew reinforcement stitching, and then cut the thread automatically at the end of the stitching. Refer to "Automatically cutting the thread" (page 65). z When you cut the threads by using the thread cutter on the side of the machine or scissors, first press (Needle position button) once to raise the needle, then raise the presser foot lever and pull the fabric to the left side of the machine, and then cut the threads. Refer to "Using the thread cutter" (page 60). Raise the buttonhole lever to its original j position. Insert a pin along the inside of one bar tack at k the end of the buttonhole stitching to prevent the stitching from being cut. b a Buttonhole lever 1 b Bracket Gently hold the end of the upper thread in g your left hand, and then start sewing. a Pin X Once sewing is completed, the machine automatically sews reinforcement stitches, then stops. 90