Brother International Innov-ís 950D Users Manual - English - Page 93

Use the seam ripper to cut towards the pin and l open the buttonhole. ■ Changing the density of the stitching Adjust the stitch length. a Memo a Seam ripper z For details, refer to "Adjusting the stitch length" (page 62). For keyhole buttonholes, use the eyelet punch z If the fabric does not feed (for example, if it to make a hole in the rounded end of the is too thick), decrease the density of the buttonhole, and then use the seam ripper to cut stitching. open the buttonhole. ■ Changing the stitch width 3 Adjust the stitch width. a a Eyelet punch Note z When using the eyelet punch, place thick paper or some other protective sheet under the fabric before punching the hole in the fabric. CAUTION ● When opening the buttonhole with the seam ripper, do not place your hands in the cutting path, otherwise injuries may result if the seam ripper slips. ● Do not use the seam ripper in any other way than how it is intended. Memo z For details, refer to "Adjusting the stitch width" (page 61). z Before sewing buttonholes, check the stitch length and width by sewing a trial buttonhole on a scrap piece of fabric. Buttonhole Stitching/Button Sewing 91