Brother International Innov-ís 950D Users Manual - English - Page 189
Adjusting the LCD, Operation beep
View all Brother International Innov-ís 950D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 189 highlights
Adjusting the LCD If nothing appears in the LCD when the sewing machine is turned on, the brightness of the LCD is either too light or too dark. In such a case, perform the following operation. Turn off the sewing machine. a ■ If the machine locks up, for example, because the thread is tangled The sewing machine beeps for four seconds and the machine automatically stops. Be sure to check for the cause of the error, and correct it before continuing to sew. ■ Canceling the operation beep When the sewing machine is purchased, it is set to beep each time an operation panel key is pressed. This setting can be changed so that the machine does not beep. Turn the power on while pressing any of the b operation panel keys except (Setting key). Turn on the sewing machine. a X The LCD comes on. Press b panel. (Setting key) in the operation Press c or . 5 X The setting screen appears. Press c (Next page key) twice. Press OFF for the buzzer. d Turn off the sewing machine, then turn it on d again. Operation beep Each time a key is pressed you will hear one beep. If an incorrect operation is performed you will hear two or four beeps. ■ If a key is pressed (correct operation) One beep sounds. ■ If an incorrect operation is performed Two or four beeps sound. X The screen for changing the beep setting appears. Press e (Back key). X The initial stitch screen appears again. Troubleshooting 187