Brother International NX-250 Users Manual - English - Page 11
Needle and presser foot, Right-side/rear view - bobbin case
View all Brother International NX-250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Needle and presser foot section Right-side/rear view 1 Buttonhole lever The buttonhole lever is used with the one-step buttonhole foot to create buttonholes. 2 Thread guide disk Pass the thread through the thread guide disk when using the needle threader to thread the needle. 3 Needle bar thread guide Pass the upper thread through the needle bar thread guide. 4 Needle plate The needle plate is marked with guides to help sew straight seams. 5 Needle plate cover Remove the needle plate cover to clean the bobbin case and race. 6 Bobbin cover Open the bobbin cover to set the bobbin. 7 Feed dogs The feed dogs feed the fabric in the sewing direction. 8 Presser foot The presser foot applies pressure consistently on the fabric as sewing takes place. Attach the appropriate presser foot for the selected stitch. 9 Presser foot holder The presser foot is attached onto the presser foot holder. 1 Presser foot dial Use the presser foot dial to adjust the amount of pressure that the presser foot applies to the fabric. 2 Handle Carry the sewing machine by its handle when transporting the machine. 3 Handwheel Turn the handwheel toward you to raise and lower the needle. The handwheel should be turned towards you (counterclockwise). 4 Air vent The air vent allows the air surrounding the motor to circulate. Do not cover the air vent while the sewing machine is being used. 5 Main power switch Use the main power switch to turn the sewing machine ON and OFF. 6 Foot controller jack Insert the plug on the end of the foot controller cable into the foot controller jack. 7 Power supply jack Insert the plug on the power cord into the power supply jack. 8 Feed dog position switch Use the feed dog position switch to lower the feed dogs. 9 Presser foot lever Raise and lower the presser foot lever to raise and lower the presser foot. Memo ● Refer to pages 9 through 12 while you are learning to use your machine. 10