Canon MultiPASS F50 MFP F50 FAX Guide - Page 33
Start, Memory sending using the platen glass
View all Canon MultiPASS F50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
I Memory sending using the platen glass • When documents are loaded into the ADF, the machine will scan documents not on the platen glass but NOTE in the ADF. You need to remove documents from the ADF in advance. 1 Press Fax to set Fax Mode. 12/03/2001 MON 15:30 Ex: F a x T e l STANDARD 2 Prepare the document and place it on the platen glass. (→ Reference Guide) • For color sending, press Color/B&W to turn on its light. (→ p. 4-1) • To adjust the resolution and contrast, → p. 4-2. 3 Dial the other party's fax number. TEL= 9057951111 Ex: • For dialing methods, → p. 4-3. • If you enter the wrong number, press Stop/Reset, then enter the correct number. • If you must first dial a digit to get an outside line ("9", for example), add a pause after that digit by pressing Redial/Pause. 4 Press Start to begin scanning. • When you use speed dialing, scanning starts automatically after a few seconds if the TIME OUT setting is on. (→ p. 9-5) NEXT PAGE :START END SCANNING:SET • If you want to scan other documents, set the next document on the platen glass and press Start. 5 Press Set to send. • To cancel sending after dialing has started, press Stop/Reset then T. (→ p. 4-9) • You can scan up to 30 different documents NOTE for memory sending. • When an error occurs during sending, the document is automatically deleted from memory, even if it was not sent completely. • If you send a color document to a fax machine that does not support color faxing, or TRY AGAIN IN B&W will be displayed in the LCD, → p. 4-1. 4 Sending Faxes 4-7