Canon SX50 Realis_E.pdf - Page 13
Installation Precautions
UPC - 013803046830
View all Canon SX50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
INSTALLATION PRECAUTIONS Ensure that the projector is installed with a minimum distance of 1 m (3.3') from its left, right, rear, and top panels to the neighboring object such as a wall. Pay Attention to Hot Air from Exhaust Vent Hot air is exhausted from the exhaust vent. Do not place any object near the exhaust vent. SAFETY INSTRUCTIONS • Do not put any spray can near the vent. The internal pressure increases due to heat, resulting in explosion. • Do not put any metallic object. It may become hot, resulting in an accident or injury. • Do not put anything such as a plant pot. • Do not put anything that may deform or deteriorate due to heat. • Do not put an audience seat near the exhaust vent. Do not put anything that may deform or discolor due to heat on the projector. The area around the exhaust vent and the cabinet above the exhaust vent become hot. Do not touch these areas, or you may get burnt. Especially, keep children away from these areas. Do Not Use in the Following Environments Do not install the projector in a humid or dusty place or a place where there is much oily smoke or cigarette smoke. Optical parts such as a lens and mirror are stained, resulting in poor picture. Do not use the projector in a place where the temperature becomes very high or low. Operating temperature: +5°C to +35°C Storage temperature: -10°C to +60°C Pay Attention to Condensation If the projector is carried from a cold place to a warm place or the room temperature is raised rapidly, dew may form on the lens and mirror due to the moisture in the atmosphere, resulting in a blurred picture. Wait until dew evaporates and a normal picture is shown. Install the Projector at Proper Position Install the projector properly. Improper installation may cause troubles and accidents. • Do not tilt the projector more than 20 degrees above and below. • Do not point the projector up. 20 degrees • Do not point the projector down. • Do not put the projector on either side. 20 degrees Do not tilt the projector more than 20 degrees above and below. 13