Canon SX50 Realis_E.pdf - Page 78
Procedure for Replacing the Lamp
UPC - 013803046830
View all Canon SX50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Procedure for Replacing the Lamp 1 Turn off the projector and disconnect the power plug from the AC outlet. Allow the projector to cool for a least 1 hour. 2 Detach the lamp cover by loosening Lamp cover a screw with a flathead screwdriver. Screw 3 Loosen two screws, turn up the Handle handle, and remove the lamp. 4 Insert a new lamp as far as it will go and secure it with two screws. * After installation, be sure to turn down the handle. 5 6 7 8 78 Install the lamp cover and tighten the screw. Lamp cover Turn on the projector. Bring up the menu and select [System settings] -> [Lamp counter]. (P74) Select [Reset] -> [OK] to reset the lamp counter. Lamp Screws MAINTENANCE
78
MAINTENANCE
Procedure for Replacing the Lamp
Turn off the projector and disconnect
the power plug from the AC outlet.
Allow the projector to cool for a least
1 hour.
Detach the lamp cover by loosening
a screw with a flathead screwdriver.
Loosen two screws, turn up the
handle, and remove the lamp.
Insert a new lamp as far as it will go
and secure it with two screws.
*
After installation, be sure to turn
down the handle.
Install the lamp cover and tighten the
screw.
Turn on the projector.
Bring
up
the
menu
and
select
[System settings] -> [Lamp counter].
(P74)
Select [Reset] -> [OK] to reset the
lamp counter.
Lamp
Screws
Handle
1
2
Screw
Lamp cover
Lamp cover
8
7
6
5
3
4