Compaq ML370 ProLiant ML370 Maintenance and Service Guide - Page 106
Hardware Requirements, Manager 2.0 or later or an NVT Novell Virtual Terminal Terminal Emulator
UPC - 720591236915
View all Compaq ML370 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
3-52 Compaq ProLiant ML370 Maintenance and Service Guide Hardware Requirements To use this level of ASR-2 over a modem, you need the following: A Compaq external Netelligent modem or compatible System Configuration Utility and Diagnostics Utility installed on the Compaq system partition of the hard drive ASR-2 configured to load Compaq Utilities after restart You can also run Compaq Utilities remotely over an IPX or IP network using the Network feature: To use Compaq Utilities on an IPX network, you must have Compaq Insight Manager 2.0 or later or an NVT (Novell Virtual Terminal) Terminal Emulator with VT100 or ANSI terminal capabilities. To use Compaq Utilities on an IP network, you must have Compaq Insight Manager 2.10 or later, or a Telnet Terminal Emulator with VT100 or ANSI capabilities. If you are notified that ASR-2 restarted the server and you have restarted to Compaq Utilities, use the Inspect Utility or Compaq Insight Manager to view the critical error in the Compaq system partition. Run Diagnostics to diagnose and resolve the problem. You can configure ASR-2 to restart the server into Compaq Utilities to diagnose the critical error or to start the operating system to return the server to operational status as rapidly as possible. When you enable ASR-2 to start the operating system, the server tries to start from the primary partition. In this mode, ASR-2 can page you if a critical error occurs, but you cannot access Compaq Utilities. When you enable ASR-2 to start Compaq Utilities, the server restarts after a critical error and loads Compaq Utilities from the Compaq system partition on the hard drive.