Compaq ML370 ProLiant ML370 Maintenance and Service Guide - Page 51
HotPlug SCSI Drive Backplane
UPC - 720591236915
View all Compaq ML370 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Removal and Replacement Procedures 2-35 Hot-Plug SCSI Drive Backplane To remove the hot-plug SCSI drive backplane: 1. Perform the preparation procedures. See "Powering Down the Server" earlier in this chapter. 2. Open the front bezel (tower model only). See "Front Bezel" earlier in this chapter. 3. Remove the large access panel. See "Large Access Panel" earlier in this chapter. 4. Remove all hard drive blanks and hot-plug hard drives. See "Hard Drive Blank" and "Hot-Plug SCSI Hard Drive" earlier in this chapter. 5. Remove the hot-plug drive cage. See "Hot-Plug Drive Cage" earlier in this chapter. 6. Remove the three Torx T-15 screws securing the hot-plug SCSI drive backplane to the hot-plug SCSI drive cage . 7. Slide the hot-plug SCSI drive backplane down slightly. Then pull it from the mounting posts . 1 1 2 1 Figure 2-31. Removing the hot-plug SCSI drive backplane Reverse steps 1 through 7 to replace the hot-plug SCSI drive backplane.