Compaq ML370 ProLiant ML370 Maintenance and Service Guide - Page 59
Utilities Access, Running Compaq Utilities - manual
UPC - 720591236915
View all Compaq ML370 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Diagnostics and Troubleshooting 3-5 Utilities Access The Compaq SmartStart and Support Software CD contains the SmartStart program and many of the Compaq utilities needed to maintain the system, including: System Configuration Utility Array Configuration Utility Array Diagnostic Utility ROMPaq Firmware Upgrade Utilities Compaq Diagnostics CAUTION: Do not select the Erase Utility when running the SmartStart and Support Software CD. This will result in data loss to the entire system. Running Compaq Utilities Compaq utilities may be accessed from the Compaq System partition on the hard drive, from diskette, or from the Compaq SmartStart and Support Software CD. Running the Utilities on the Compaq System Partition If the system was installed using SmartStart, the Compaq utilities will automatically be available on the Compaq system partition. The Compaq system partition could also have been created during a manual system installation. To run the utilities on the Compaq system partition, boot the system and press F10 when you see: "Press F10 for Compaq system partition utilities." Then select the utilities from the menu. The System Configuration Utility is available under the System Configuration menu. The Array Configuration Utility is available under the System Configuration menu. Compaq Diagnostics (Test and Inspect) are available under the Diagnostics and Utilities menu. The ROMPaq Firmware Upgrade Utility is available under the Diagnostics and Utilities menu.