Compaq ML370 ProLiant ML370 Maintenance and Service Guide - Page 79
RESUME - F1 KEY, Enable the Array Accelerator.
UPC - 720591236915
View all Compaq ML370 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Diagnostics and Troubleshooting 3-25 Table 3-2 POST Error Messages continued Error Code Audible Beeps 1797 - Drive Array- None Array Accelerator Read Error Occurred. Data in Array Accelerator has been lost. Array Accelerator is disabled. 1798 - Drive Array- None Array Accelerator Write Error Occurred. Array Accelerator is disabled. 1799 - Drive Array- None Drive(s) Disabled due to Array Accelerator Data Loss. Select "F1" to continue with logical drives disabled. Select "F2" to accept data loss and to re-enable logical drives. Beeps only: 2 Long 2L Beeps only: 2 Long + 2 Short 2L, 2S (Run System None Configuration Utility - F10 key) (RESUME - F1 KEY) None Probable Source of Problem Hard parity error while reading data from posted-writes memory Recommended Action Enable Array Accelerator. Hard parity error while writing data to posted-writes memory Enable the Array Accelerator. Volume failed due to loss of data in posted-writes memory. Press F1 to continue with logical drives disabled or F2 to accept data loss and re-enable logical drives. No valid memory is present in the system. Power is cycled. Temperature too hot. Processor fan not installed or spinning. A configuration error occurred during POST. Replace failed memory with valid memory. Check fans. Press F10 to run System Configuration Utility. As indicated to continue Press F1.