Compaq ML370 ProLiant ML370 Maintenance and Service Guide - Page 62
Table 3-2, POST Error Messages, Error Code, Audible Beeps, Probable Source of Problem - beep codes
UPC - 720591236915
View all Compaq ML370 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
3-8 Compaq ProLiant ML370 Maintenance and Service Guide Error Code A Critical Error occurred prior to this power-up Unsupported Processor Detected System Halted FATAL ROM ERROR: The System ROM is not properly programmed 101 - ROM Error 101 - I/O ROM Error 102 - System Board Failure 104 - ASR-2 Timer Failure 105 - Current System ROM is corrupt- now booting redundant System ROM 162 - System Options Not Set 163-Time & Date Not Set 164 - Memory Size Error 172 - Configuration Nonvolatile Memory Invalid 173 - Slot ID Mismatch 174 - Configuration/ Slot Mismatch Device Not Found Table 3-2 POST Error Messages Audible Beeps None 1 long, 1 short Probable Source of Problem A catastrophic system error, which caused the server to crash, has been logged. Processor not supported by current system ROM 1 long, 1 short ROM programmed in factory incorrectly Recommended Action Run Diagnostics. Replace failed assembly as indicated. Check documentation for supported processors, and if supported, remove the processor and update the system to latest ROM. Replace the physical ROM part. 1 long, 1 short None None System ROM checksum Options ROM checksum DMA, timers, and so on None System board failure 2L Non-booted ROM image is corrupt Run Diagnostics. Replace failed assembly as indicated. Run Diagnostics. Replace failed assembly as indicated. Replace the system board. Run the Compaq System Configuration Utility. Run Diagnostics. Replace failed assembly as indicated. Flash the ROM utilizing ROMPaq. 2S Configuration incorrect Run the System Configuration Utility and correct. 2S Invalid time or date in configuration memory Run the System Configuration Utility and correct. 2S Configuration memory incorrect Run the System Configuration Utility and correct. None Nonvolatile configuration corrupt Run the System Configuration or jumper installed Utility and correct. None Board replaced, configuration not Run the System Configuration updated Utility and correct. None PCI board not found Run the System Configuration Utility and correct. continued