D-Link DGS-1520 User Manual - Page 166

DGS-1520 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide After clicking the Add Rule button next to an IP type profile, the following page will appear. Figure 5-51 VLAN Mapping Profile (IP, Add Rule) Window The fields that can be configured are described below: Parameter Rule ID Source IP Address (IP/Mask) Destination IP Address (IP/Mask) DSCP Source Port Destination Port IP Protocol Action 802.1p Priority New Inner VID Description Enter the VLAN mapping rule ID here. If not specified, the rule ID begins from 10 and is incremented by 10 for every new rule. The range is from 1 to 10000 Enter the source IPv4 address and subnet mask here. Enter the destination IPv4 address and subnet mask here. Enter the DSCP value here. The range is from 0 to 63. Enter the source TCP/UDP port number here. The range is from 1 to 65535. Enter the destination TCP/UDP port number here. The range is from 1 to 65535. Enter the Layer 3 IP protocol value here. The range is from 0 to 255. Select the action that will be taken here. Options to choose from are: • Dot1q-Tunnel - Specifies that the outer-VID will be added for matched packets. • Translate - Specifies that the outer-VID will replace the outer-VID of the matched packets. Select the 802.1p priority value here. The range is from 0 to 7. A higher value has a higher priority. After selecting Dot1q-Tunnel as the action, enter the new inner VLAN ID here. The range is from 1 to 4094. Click the Back button to return to the previous window. Click the Apply button to accept the changes made. 156