D-Link DGS-1520 User Manual - Page 244

DGS-1520 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide The fields that can be configured are described below: Parameter IP Address Mask Gateway Null Interface Backup State Description Enter the IPv4 address for this route here. Tick the Default Route option to use the default route as the IPv4 address. Enter the IPv4 network mask for this route here. Enter the gateway address for this route here. Select to enable or disable the NULL interface here. Select the backup state option here. Options to choose from are: • Primary - Specifies the route as the primary route to the destination. • Backup - Specifies the route as the backup route to the destination. • Weight - Specifies a weight number greater than zero, but less than the maximum paths number. This number is used to replicate identical route paths (multiple copies) in the routing table, so the paths get more chance of being hit for traffic routing. Enter the weight value in the space provided. The range is from 1 to 4. Click the Apply button to accept the changes made. Click the Delete button to remove the specific entry. Enter a page number and click the Go button to navigate to a specific page when multiple pages exist. IPv4 Route Table This window is used to display and configure the IPv4 route table settings. To view the following window, click L3 Features > IPv4 Route Table, as shown below: Figure 6-21 IPv4 Route Table Window The fields that can be configured are described below: Parameter IP Address Network Address RIP OSPF Connected Description Select and enter the single IPv4 address here. Select and enter the IPv4 network address here. In the first space enter the network prefix and in the second space enter the network mask. Select this option to display only RIP routes. Select this option to display only OSPF routes. Select this option to display only connected routes. 234