D-Link DGS-1520 User Manual - Page 249
L3 Features > URPF Settings, IP Access List Name
View all D-Link DGS-1520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 249 highlights
DGS-1520 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide organizational network will allow the traffic and potentially be open to a number of different attack types. Unicast RPF helps to mitigate problems caused by malformed or forged IPv4/IPv6 source addresses passing through the router. To view the following window, click L3 Features > URPF Settings, as shown below: Figure 6-27 URPF Settings Window The fields that can be configured in URPF Global Settings are described below: Parameter URPF State Description Select to globally enable or disable the URPF state here. Click the Apply button to accept the changes made. NOTE: When enabled, the hardware routing table needs to be searched using the Session Initiation Protocol (SIP) first and then using the Dynamic Inspection Protocol (DIP). This is achieved by splitting the table into two halves so that the size of the IP routing table will be reduced by half. This will not take effect until the configuration was saved and the Switch was rebooted. The fields that can be configured in URPF Port Default Settings are described below: Parameter Unit From Port - To Port Reachable Via IP Access List Name IPv6 Access List Name Description Select the Switch unit that will be used for this configuration here. Select the range of ports that will be used for this configuration here. Select this option to use the default reachable via setting. Select this option to use the default IP access list configuration. Select this option to use the default IPv6 access list configuration. Click the Apply button to accept the changes made. 239