D-Link DGS-1520 User Manual - Page 333

DGS-1520 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide Parameter RP Address Description Enter the RP address that will be used here. Click the Find button to find and display an entry based on the information entered. Click the Clear button to clear the entries from the table based on the information entered. MSDP Static RPF Settings This window is used to display and configure the MSDP static RPF settings. Before configuring a static RPF peer, an MSDP peer must be added first. If the RP prefix list is specified, the peer will be a static RPF peer only for RPs in the prefix list. When multiple static RPF peers are specified without an RP prefix list, only the connected peer whose address is smallest will be the active static RPF peer. If an MSDP peer is configured as a static RPF peer multiple times, only the last configuration takes effect. If there is one MSDP peer only, this MSDP peer works as a static RPF peer. To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > MSDP > MSDP Static RPF Settings, as shown below: Figure 6-127 MSDP Static RPF Settings Window The fields that can be configured are described below: Parameter Peer Address RP List Description Enter the MSDP peer address here. Enter the name of the standard IP access list that defines the RP prefix list here. This string can be up to 32 characters long. Click the Apply button to accept the changes made. Click the Find button to find and display an entry based on the information entered. 323