Dell PowerConnect Brocade M6505 Hardware Reference Manual - Page 31
Configuring the SAN I/O Module, In this Items required
View all Dell PowerConnect Brocade M6505 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Chapter Configuring the SAN I/O Module 3 In this chapter •Items required 19 •Modifying the SAN I/O Module IP address 20 •Connecting to the SAN I/O Module using Web Tools 24 •Connecting the SAN I/O Module to the Ethernet network 24 •Connecting the SAN I/O Module to the fabric 24 NOTE Although the SAN I/O Module is configured at the factory for Access Gateway (AG) mode, you can enable it for Fabric OS Native mode. For more information, refer to "Changing from Access Gateway mode to Native Fabric mode" on page 31. Items required The following items are required for configuring and connecting the SAN I/O Module for use in a network and fabric: • The SAN I/O Module to be installed in the Dell M1000e Blade Server Enclosure. • If required, a management workstation (computer) that has a terminal emulator (such as HyperTerminal) or a keyboard, video, and mouse (KVM) device. This is only required if you are not changing the SAN I/O Module IP address through the Dell M1000e Blade Server Enclosure GUI or CLI management programs. • An unused IP address and corresponding subnet mask and gateway address, unless DHCP is used. • If required, a serial cable to connect to the SAN I/O Module serial console port. NOTE The serial cable is only required if you are not changing the SAN I/O Module IP address through the Dell M1000e Blade Server Enclosure GUI or CLI management programs. • Access to an FTP server for backing up the SAN I/O Module configuration. Brocade M6505 16 Gbps Fibre Channel SAN I/O Module Hardware Reference Manual 19 53-1002576-02