Dell PowerEdge M640 EMC for VRTX enclosure Installation and Service Manual - Page 104
If you assign a new system and/or setup password with the jumper on pins 2 and 3
View all Dell PowerEdge M640 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
NOTE: If you assign a new system and/or setup password with the jumper on pins 2 and 3, the system disables the new password(s) the next time it boots. 6. Turn off the system by using the operating system commands or the CMC. 7. Remove the system from the enclosure to access the jumpers. 8. Move the jumper on the system-board jumper from pins 1 and 2 to pins 2 and 3. 9. Install the system in the enclosure. 10. Turn on the system. 11. Assign a new system and/or setup password. 104 Jumpers and connectors
NOTE:
If you assign a new system and/or setup password with the jumper on pins 2 and 3, the system disables the
new password(s) the next time it boots.
6.
Turn off the system by using the operating system commands or the CMC.
7.
Remove the system from the enclosure to access the jumpers.
8.
Move the jumper on the system-board jumper from pins 1 and 2 to pins 2 and 3.
9.
Install the system in the enclosure.
10.
Turn on the system.
11.
Assign a new system and/or setup password.
104
Jumpers and connectors