Dell PowerEdge M640 EMC for VRTX enclosure Installation and Service Manual - Page 83

Installing the storage controller card

Get Dell PowerEdge M640 PDF manuals and user guides View all Dell PowerEdge M640 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 83 highlights

Figure 44. Removing the storage controller card Next steps Install the storage controller card. Installing the storage controller card Prerequisites Follow the safety guidelines listed in Safety instructions on page 45. Steps 1. Align the slots on the edge of the storage controller card with the tabs on the support bracket. CAUTION: To prevent damage to the storage controller card, you must hold the card only by its edges. 2. Lower the storage controller card onto the connector on the system board. 3. Using the Phillips #2 screwdriver, tighten the retention screws on the drive backplane cable connector to secure the card to the system board. Installing and removing system components 83

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
Figure 44. Removing the storage controller card
Next steps
Install the storage controller card.
Installing the storage controller card
Prerequisites
Follow the safety guidelines listed in
Safety instructions
on page 45.
Steps
1.
Align the slots on the edge of the storage controller card with the tabs on the support bracket.
CAUTION:
To prevent damage to the storage controller card, you must hold the card only by its edges.
2.
Lower the storage controller card onto the connector on the system board.
3.
Using the Phillips #2 screwdriver, tighten the retention screws on the drive backplane cable connector to secure the card to the
system board.
Installing and removing system components
83