Dell PowerEdge R440 EMC Installation and Service Manual - Page 103
Next steps, Prerequisites, Steps, Removing internal PERC riser
![]() |
View all Dell PowerEdge R440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
Figure 69. Removing internal PERC riser 5. Turn the internal riser so that the PERC card is facing up. 6. Press the cable connector and disconnect the cable connected to the internal PERC card. Figure 70. Disconnecting the cable from internal PERC card Next steps 1. Install the air shroud. 2. Follow the procedure listed in After working inside your system on page 59. 3. Install the internal PERC card. Installing the internal PERC riser Prerequisites Follow the safety guidelines listed in Safety instructions. Steps 1. Connect the cable to the internal PERC card. Installing and removing system components 103
![](/manual_guide/products/dell-poweredge-r440-emc-installation-service-manual-3131fb9/103.png)
Figure 69. Removing internal PERC riser
5.
Turn the internal riser so that the PERC card is facing up.
6.
Press the cable connector and disconnect the cable connected to the internal PERC card.
Figure 70. Disconnecting the cable from internal PERC card
Next steps
1.
Install the air shroud.
2.
Follow the procedure listed in
After working inside your system
on page 59.
3.
Install the internal PERC card.
Installing the internal PERC riser
Prerequisites
Follow the safety guidelines listed in
Safety instructions
.
Steps
1.
Connect the cable to the internal PERC card.
Installing and removing system components
103