Dell PowerEdge R440 EMC Installation and Service Manual - Page 90
Internal PERC riser, Removing the internal PERC riser
View all Dell PowerEdge R440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
• Do not press on the heat sink fins. • Ensure that the pin 1 indicator on the heat sink is aligned with the pin 1 indicator on the bracket before placing the heat sink onto the processor and bracket. Figure 48. Installing the heat sink onto the processor Next steps 1. Install the processor and heat sink module. 2. Install the air shroud. 3. Follow the procedure listed in After working inside your system on page 59. Internal PERC riser Removing the internal PERC riser Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure listed in Before working inside your system. 3. Remove the air shroud. Steps 1. Open the cable guiding latch for easy access. 2. Lower the plunger. 3. Press the cable connector and disconnect the PERC cable from the backplane. 4. Hold the blue touch points and lift the internal PERC riser out of the system. 90 Installing and removing system components