Dell PowerEdge R440 EMC Installation and Service Manual - Page 130
Installing the left control panel
View all Dell PowerEdge R440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
Figure 105. Removing the cable cover 3. Using a Phillips #1 screwdriver, remove the screws that connect the control panel to the system. Figure 106. Removing left control panel 4. Holding by the sides, remove the left control panel assembly away from the system. Next steps Install the left control panel. Installing the left control panel Prerequisites Follow the safety guidelines listed in Safety instructions. Steps 1. Route the control panel cable through the side wall of the system. 2. Align the left control panel assembly with the control panel slot on the system and place the assembly in the slot on the system. 3. Connect the control panel cable to the system board connector. 4. Using Phillips #1 screwdriver, install the screws that secure the cable cover to the system. 130 Installing and removing system components