Dell PowerEdge R440 EMC Installation and Service Manual - Page 50
System Security, Viewing System Security, System Security Settings details
![]() |
View all Dell PowerEdge R440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Option Performance Setting Description System Security You can use the System Security screen to perform specific functions such as setting the system password, setup password and disabling the power button. Viewing System Security To view the System Security screen, perform the following steps: Steps 1. Power on, or restart your system. 2. Press F2 immediately after you see the following message: F2 = System Setup NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then restart your system and try again. 3. On the System Setup Main Menu screen, click System BIOS. 4. On the System BIOS screen, click System Security. System Security Settings details About this task The System Security Settings screen details are explained as follows: Option Description CPU AES-NI Improves the speed of applications by performing encryption and decryption by using the Advanced Encryption Standard Instruction Set (AES-NI). This option is set to Enabled by default. System Password Enables you to set the system password. This option is set to Enabled by default and is read-only if the password jumper is not installed in the system. Setup Password Enables you to set the system setup password. This option is read-only if the password jumper is not installed in the system. Password Status Enables you to lock the system password. This option is set to Unlocked by default. TPM Security NOTE: The TPM menu is available only when the TPM module is installed. Enables you to control the reporting mode of the TPM. The TPM Security option is set to Off by default. You can only modify the TPM Status TPM Activation, and the Intel TXT fields if the TPM Status field is set to either On with Pre-boot Measurements or On without Pre-boot Measurements. Table 40. TPM 1.2 security information Option TPM Information Description Changes the operational state of the TPM. This option is set to No Change by default. TPM Firmware Indicates the firmware version of the TPM. TPM Status Specifies the TPM status. TPM Command Controls the Trusted Platform Module (TPM). When set to None, no command is sent to the TPM. When set to Activate, the TPM is enabled and activated. 50 Pre-operating system management applications
![](/manual_guide/products/dell-poweredge-r440-emc-installation-service-manual-3131fb9/50.png)