Dell PowerEdge R440 EMC Installation and Service Manual - Page 105
Installing PERC card into the internal PERC riser, Steps, Next steps, Prerequisites
![]() |
View all Dell PowerEdge R440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
Steps 1. Using a Phillips #2 screwdriver, remove the screw that secures the PERC card to the internal PERC riser. 2. Pull the PERC card out of the connector on the internal PERC riser. Figure 73. Removing the PERC card from the internal PERC riser Next steps 1. Install the PERC card into the internal PERC riser. 2. Replace the air shroud. 3. Follow the procedure listed in After working inside your system. Installing PERC card into the internal PERC riser Prerequisites 1. Follow the safety guidelines listed in Safety instructions. Steps 1. Insert the PERC card into the internal PERC riser and push the card in. 2. Using a Phillips #2 screwdriver, replace the screw to secure the PERC card on the internal PERC riser. Installing and removing system components 105
![](/manual_guide/products/dell-poweredge-r440-emc-installation-service-manual-3131fb9/105.png)