Dell PowerEdge R440 EMC Installation and Service Manual - Page 132
Installing the right control panel
View all Dell PowerEdge R440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 132 highlights
Figure 109. Removing right control panel 4. Holding the control panel by its sides, remove the control panel away from the system. Next steps Install the right control panel. Installing the right control panel Prerequisites Follow the safety guidelines listed in Safety instructions. Steps 1. Route the control panel cable through the side wall of the system. 2. Align the right control panel with the control panel slot on the system and place the assembly in the slot on the system. 3. Connect the control panel cable to the connector on the system board and lower the cable latch to secure the cable in place. 4. Using a Phillips #1 screwdriver, install the screws that secure the cable cover to the system. Figure 110. Installing the cable cover 132 Installing and removing system components