Dell PowerEdge R440 EMC Installation and Service Manual - Page 107
Removing the M.2 SSD module
View all Dell PowerEdge R440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
Figure 75. Installing the M.2 SSD module Next steps 1. Install the BOSS card. NOTE: The procedure to install the BOSS card is similar to the removing an expansion card. 2. Install the air shroud.. 3. Follow the procedure listed in After working inside your system. Removing the M.2 SSD module Prerequisites 1. Follow the safety guidelines listed in Safety instructions on page 58 2. Follow the procedure listed in Before working inside your system on page 59. 3. Remove the air shroud. 4. Remove the BOSS card. NOTE: The procedure to remove the BOSS card is similar to the removing an expansion card. Steps 1. Loosen the screw and lift the retention strap that secures the M.2 SSD module on the BOSS card. 2. Lift the M.2 SSD module and slide it out of the connector on the BOSS card. Installing and removing system components 107