Dell PowerEdge R440 EMC Installation and Service Manual - Page 72
Drives, Removing a drive blank
View all Dell PowerEdge R440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Drives Removing a drive blank The procedure for removing 2.5-inch and 3.5-inch drive blanks is identical. Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. If installed, remove the front bezel. CAUTION: To maintain proper system cooling, drive blanks must be installed in all empty drive slots. CAUTION: Mixing drive blanks from previous generations of PowerEdge servers is not supported. Steps Press the release button, and slide the drive blank out of the drive slot. Figure 30. Removing a drive blank Next steps 1. Install a drive or Installing the hard drive backplane on page 115 Installing a drive blank The procedure for installing 2.5-inch and 3.5-inch drive blanks is identical. Prerequisites 1. Follow the safety guidelines listed in Safety instructions on page 58. 2. If installed, remove the front bezel. CAUTION: Mixing drive blanks from previous generations of PowerEdge servers is not supported. Steps Insert the drive blank into the drive slot, and push the blank until the release button clicks into place. 72 Installing and removing system components