Dell PowerVault DL2000 DL2000 Hardware Owner's Manual - Page 112
Expansion-Card Riser Boards, Removing the Left Expansion-Card Riser Board
View all Dell PowerVault DL2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 112 highlights
11 To test the newly installed battery, turn off the system and disconnect it from the electrical outlet for at least an hour. 12 After an hour, reconnect the system to its electrical outlet and turn it on. 13 Enter the System Setup program and if the time and date are still incorrect, see "Getting Help" on page 167 for instructions on obtaining technical assistance. Expansion-Card Riser Boards Removing the Left Expansion-Card Riser Board CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet. 2 Open the system. See "Opening the System" on page 67. 3 Remove any expansion cards from the left riser expansion-card slots. See "Removing an Expansion Card" on page 90. 4 Remove the expansion-card cage. See "Removing the Expansion-Card Cage" on page 91. 5 Remove the expansion-card riser board: a Pull the expansion-card riser release pin. See Figure 3-23. b While pulling the release pin, slide the riser board away from the expansion card openings. c Lift the riser board from the six securing tabs. 112 Installing System Components