Dell PowerVault DL2000 DL2000 Hardware Owner's Manual - Page 95
Removing the DRAC Card and Cables
View all Dell PowerVault DL2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
7 Connect the two short ribbon cables to the DRAC card and the system board. See Figure 6-2 for the connector locations NOTICE: Be careful when attaching cables to the system board that you do not damage the surrounding system board components. a Connect one cable to connector 1 on the DRAC card and to DRAC_CONN1 on the system board. b Connect the second cable to connector 2 on the DRAC card and to DRAC_CONN2 on the system board. Reinstall the central riser board. See "Installing the Central Riser Board" on page 115. NOTICE: When detaching the DRAC cables from the system board, squeeze the metal ends of the cable connectors and gently work the connector out of the socket. Do not pull on the cable to unseat the connector. Doing so can damage the cable. 8 Add any PCI cards that were removed from the central riser. See "Installing an Expansion Card" on page 88. 9 Close the system. See "Closing the System" on page 67. 10 Reconnect the system and peripherals to their power sources, and turn them on. See the DRAC card documentation for information on configuring and using the DRAC card. Removing the DRAC Card and Cables 1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet. 2 Open the system. See "Opening the System" on page 67. 3 Remove the central riser board. See "Removing the Central Riser Board" on page 114. 4 Remove the DRAC card cables from the system board by squeezing the metal tabs inward and pulling up. 5 Remove the DRAC card cables from the DRAC connectors by squeezing the metal tabs inward and pulling out. 6 Remove the DRAC card by pressing outward on the front standoffs and lifting the DRAC card out of the system. 7 Reinstall the central riser board. See "Installing the Central Riser Board" on page 115. Installing System Components 95