Dell PowerVault DL2000 DL2000 Hardware Owner's Manual - Page 74
hole on the hard drive with the hole labeled SATAu on the hard drive, lign the bottom rear screw
View all Dell PowerVault DL2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
2 Viewing the assembly as shown in Figure 3-6, align the bottom rear screw hole on the hard drive with the hole labeled "SATAu" on the hard drive carrier. When aligned correctly, the rear of the interposer will be flush with the rear of the hard-drive carrier. 3 Attach the four screws to secure the hard drive to the hard-drive carrier. See Figure 3-6. 4 Attach the interposer card to the rear of the SATA hard drive: a Angle the top of the interposer card into the inside top carrier rail so that the tabs on the interposer card bracket attach to the slots on the inside of the carrier rail. See Figure 3-6. b Rotate the bottom end of the card toward the hard drive to seat the connector. See Figure 3-6. c Push the bottom end of the card to the hard drive until the latch on the card bracket clicks into place. 74 Installing System Components