Dell PowerVault DL2000 DL2000 Hardware Owner's Manual - Page 93
Replacing the Expansion-Card Cage, DRAC Card and Cables, Installing the DRAC Card and Cables
View all Dell PowerVault DL2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Replacing the Expansion-Card Cage CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1 Align the guides on each end of the expansion-card cage with the pins on the system board, and lower the cage. See Figure 3-15. 2 Install any expansion cards. 3 Reconnect all expansion-card cables. 4 Close the system. See "Closing the System" on page 67. DRAC Card and Cables CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. The optional Dell Remote Access Controller (DRAC) provides a set of advanced features for managing the server remotely. The following procedure describes the steps for installing or removing the optional DRAC card and cables. Installing the DRAC Card and Cables 1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet. 2 Open the system. See "Opening the System" on page 67. 3 If necessary, remove the plastic filler plug from the system back panel. See Figure 3-16. 4 Remove the central riser board. See "Removing the Central Riser Board" on page 114. Installing System Components 93