Dell PowerVault DL2000 DL2000 Hardware Owner's Manual - Page 81
Installing the Cooling Shroud, Fan Brackets, Removing the Fan Bracket
View all Dell PowerVault DL2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Installing the Cooling Shroud 1 Align the hinges on the shroud pivots located on either end of the fan bracket. See Figure 3-9. 2 Slowly lower the shroud straight down into the system until the fan connector engages and the latches snap into place. Fan Brackets Removing the Fan Bracket CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1 Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet. 2 Open the system. See "Opening the System" on page 67. 3 Remove the cooling shroud. See "Removing the Cooling Shroud" on page 80. 4 Remove the SAS controller daughter card. See "Removing a SAS Controller Daughter Card" on page 87 5 Remove the fans from the fan bracket. See "Removing a System Fan" on page 78. 6 Remove the fan bracket from the system: a Press down on the release latch on the left side of the fan bracket. See Figure 3-10. If the bracket does not disengage completely, push down slightly on the bracket when releasing the latch. b Rotate the left side of the bracket upward, releasing the plastic clip from its slot in the system board tray. c Draw the bracket out of the system. Installing System Components 81