Dell PowerVault DL2000 DL2000 Hardware Owner's Manual - Page 99
Removing the Optical Drive Cable, optical drive.
View all Dell PowerVault DL2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Removing the Optical Drive Cable CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1 Turn off the system, including any attached peripherals, and disconnect the system from its electrical outlet. 2 Remove the bezel. See "Removing the Front Bezel" on page 65. 3 Open the system. See "Opening the System" on page 67. 4 Release the CD-to-side plane cable from the side plane by pressing outward on the optical drive data cable ejectors until they reach the locked position. 5 Remove the cable from the cable guides on the cooling shroud. 6 Remove the CD-to-side plane cable from the back of the optical drive. See Figure 3-17. Installing the Optical Drive Cable 1 Connect the CD-to-side plane cable (labeled CD) to the back of the optical drive. 2 Route the cable on the side of the cooling shroud and then through the cable guides on the cooling shroud. 3 With the optical drive data cable ejectors in the open position on the side plane, insert the cable (labeled sideplane) into the connector until the ejectors lock. 4 Close the system. See "Closing the System" on page 67. 5 Reconnect the system and peripherals to their power sources, and turn them on. Installing System Components 99