Dell PowerVault DR6000 Owners Manual - Page 63
Network Daughter Card, Removing The Network Daughter Card
View all Dell PowerVault DR6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
10. Close the system. 11. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals. Network Daughter Card Removing The Network Daughter Card CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals. 2. Open the system. 3. If installed, remove expansion card(s) from the expansion-card riser 2. 4. Using a #2 Phillips screwdriver, loosen the two captive screws that secure the network daughter card to the system board. 5. Hold the network daughter card by the edges on either side of the touch point and lift to remove it from the connector on the system board. 6. Slide the network daughter card away from the back of the system until the NIC connectors are clear of the slot in the back panel. 7. Lift the network daughter card out of the chassis. Figure 33. Removing and Installing the Network Daughter Card 1. captive screw sockets (2) 3. captive screws (2) 5. network daughter card 2. connector on the system board 4. touch point 6. back panel slot for RJ-45 connectors 63