Edimax EW-7238RPD Manual - Page 20

depending on which frequency, you previously set up, II-3., Resetting the Wireless Extender

Page 20 highlights

frequency band. In step 1 please activate WPS on your router/access point for the alternate frequency 2.4GHz or 5GHz depending on which frequency you previously set up. Note: Please check the instructions for your wireless router/access point to confirm how long you need to hold down its WPS button to activate WPS for 2.4GHz or 5GHz. Some brands of router/access point may not support WPS for 5Ghz - in this case, please use iQ Setup instead. II-3. Resetting the Wireless Extender If you experience problems with your Wi-Fi extender you can reset the extender back to factory default settings. This resets all settings back to default. To reset the extender, press and hold the WPS/Reset button for 10 seconds until the power LED ( ) is flashing. The extender will re-initialize and the power LED ( ) will display on when the extender is ready (see I-3. LED Status). 20

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89

20
frequency band. In step 1 please activate WPS on your router/access point
for the alternate frequency 2.4GHz or 5GHz
depending on which frequency
you previously set up
.
Note:
Please check the instructions for your wireless
router/access point to confirm how long you need to
hold down its WPS button to activate WPS for 2.4GHz
or 5GHz. Some brands of router/access point may not
support WPS for 5Ghz
in this case, please use iQ
Setup instead.
II-3.
Resetting the Wireless Extender
If you experience problems with your Wi-Fi extender you can reset the
extender back to factory default settings. This resets
all
settings back to
default.
To reset the extender, press and hold the WPS/Reset button for 10 seconds
until the power LED (
) is flashing. The extender will re-initialize and the
power LED (
) will display on when the extender is ready (see
I-3.
LED
Status
).