Fluke 1586A/2DS Product Manual - Page 133
Command DATA:LAST? or DATA:READ? was
View all Fluke 1586A/2DS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
7 Error Messages and Troubleshooting Error Messages Error Code Error 1331 Error 1333 Error 1334 Error 1337 Error 1338 Error 1339 Error 1340 Error 1341 Error 1601 Error 1602 Error 1603 Table 7-1. Error Messages (cont.) Error Message Causes and Solutions Command incomplete Cause: An incomplete command line was received. Solution: Make sure that correct command was sent. Invalid channel number Cause: Invalid channel number was found by command parser. This could be caused by a wrong format. Solution: Check the parameter and try again. Illegal channel count Cause: The number of channels exceeds the limit when parse the channel list. Solution: Check the parameter and try again. Operation not allowed Cause: Operation is not allowed for current configuration, and the channel is not in scan list. Make sure that you have input the command with correct parameters and channel ID. Solution: Check the parameter and try again. Operation not allowed in DMM mode Cause: Operation is not allowed in DMM mode. Solution: Use command *RST to reset to factory default. Memory is empty Cause: Command DATA:LAST? or DATA:READ? was received, but data is not available. Solution: Check the trigger settings, and make sure that the Instrument is properly triggered for scan. File name too long Cause: More than 30 characters were found in filename which specified in command MEM:LOG:READ? or MMEM:LOG:READ? Solution: Check the parameter and try again. Scan sweep in process Cause: Operation not allowed while scan is in progress. Solution: Send command ABORt to stop the scan. Error copying file Cause: File coping failed while running SYSTem:DFU command because source is missing. Solution: Check to see if the file is in the memory. Error modifying file property Cause: Failed to change file property while running SYSTem:DFU command. Solution: Cycle the power. If the error occurs again, contact Fluke (see Chapter 1). USB memory not ready Cause: USB drive not ready for recording or memory operations. Solution: Install the USB drive. See Chapter 2. 7-19 MyFlukeStore Shop for Fluke products online at: www. .com 1.888.610.7664