Fluke 1586A/2DS Product Manual - Page 69
Table 3-9. Totalizer Channel Configuration, Function
View all Fluke 1586A/2DS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
1586A Users Manual Set up a totalizer channel as follows (see Table 3-9): 1. Connect the wire to the TOT terminal of the plug then insert the plug into the rear- panel DIO/TOT port. 2. Set the channel to ON (see "Set Channels to ON or OFF" on page 3-12). When the channel is set to ON, a channel configuration sequence shows on the display that steps the user through an initial configuration sequence as shown in Table 3-9. If the channel was previously configured, push to cancel the configuration sequence to use the last channel configuration. 3. Use the information in Table 3-9 to configure the totalizer channel. Push or to highlight the channel setting then push to edit the setting. 4. To see the totalizer count, monitor Ch402 in the Scan/Monitor menu. Table 3-9. Totalizer Channel Configuration 1 2 3 Item Function Input a custom alpha-numeric label to help identify the channel (optional). Read mode selection. See "Read Mode" on page 3-25. Set the Debounce feature to ON or OFF. See "Debounce" on page 3-25. hcn022.eps 3-26 MyFlukeStore Shop for Fluke products online at: www. .com 1.888.610.7664