Fluke 1586A/2DS Product Manual - Page 89
Basic Scan Procedures
View all Fluke 1586A/2DS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
4 Scan/Monitor, Record, and Data Scan Automatic Power Loss Scan Resume In the event that the Product experiences a loss of mains power while a scan is in progress, it can be configured to resume the scan when mains power comes on. This feature is referred to as "Power Loss Resume State". Note This setting is located in the Instrument Setup menu and not the Test Setup menu. Unlike when a new scan is started, the Product will resume recoding to the file that it was recording to when the mains power was lost. To turn on this feature: 1. Push . 2. Push or to highlight Resume Scan then . 3. Set to ON then push . Basic Scan Procedures Start a Scan To start a scan: Note Once a scan is started, the scan must be paused or stopped before the Channel Setup or the Instrument Setup menu can be accessed. 1. Configure the Test Setup. See "Configure a Scan" on page 4-6. 2. Set all channels to be scanned to ON. See "Set Channels to ON of OFF" in Chapter 3. 3. Push . 4. Start the scan as follows: • For the Interval trigger type: Push to start the scan. The scan completes the amount of scan cycles set then automatically stops. At any time, push again to stop the test or push to pause the test. If automatic recording is set to OFF, push to record data. • For the External trigger type: Push to start the scan. The scan is triggered by a low condition in the rear-panel Trig input. Once the low condition is detected, the scan sweep starts and runs as directed by the interval configuration. When the low condition that triggered the scan is removed, the Product will finish the scan in progress then stop and wait for next external trigger. 4-11 MyFlukeStore Shop for Fluke products online at: www. .com 1.888.610.7664