Fluke 726 FE 726 Users Manual - Page 48
Sourcing Pressure, of torque between the pressure module
View all Fluke 726 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
726 Users Manual Sourcing Pressure The Calibrator sources pressure by measuring pressure supplied by a pump or other sources, and displaying the pressure in the SOURCE field. Figure 18 shows how to connect a pump to a Fluke pressure module which makes it a calibrated source. Many ranges and types of pressure modules are available from Fluke, see "Accessories". Before using a pressure module, read its instruction sheet. The modules vary in use, media, and accuracy. Attach the appropriate pressure module for the process pressure to be tested. Proceed as follows to source pressure: WWarning To avoid a violent release of pressure in a pressurized system, shut off the valve and slowly bleed off the pressure before attaching the pressure module to the pressure line. WCaution To avoid mechanically damaging the pressure module: • Never apply more than 10 ft.-lb. (13.5 Nm) of torque between the pressure module fittings, or between the fittings and the body of the module. Always apply appropriate torque between the pressure module fitting and connecting fittings or adapters. • Never apply pressure above the rated maximum printed on the pressure module. • Use the pressure module only with specified materials. Refer to the printing on the pressure module or the pressure module instruction sheet for the acceptable material compatibility. 38