HP Color 9850mfp Service Manual - Page 430
avoided and then move the wire in the notch, 6] into each pulley.
View all HP Color 9850mfp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 430 highlights
III DIS./ASSEMBLY TRAY UP/DOWN 6. Insert the up/down wire A [2] into the hole [1] provided on the upper surface of the HCI main body. 7. Reinstall the up/down wire A [2] onto the guide pulleys [3], [4] and [5] in this order. Note: • When reinstalling the up/down wire A [2] onto the guide pulleys [3], [4] and [5], be sure to insert the wire into the pulley through the notch [6] provided on the side of each pulley and then move the wire cover [7] of each pulley to the wire that has been already inserted. When moving the wire cover [7], move it first to the position where the notch [6] can be avoided and then move the wire in the notch [6] into each pulley. 8. Insert the up/down wire A [2] into the wire installation hole [9] provided at the middle of the up/down drive shaft [8]. Note: • The up/down drive shaft [8] is provided with 3 wire installation holes each on the front side and the rear side. In this step, the wire installation hole at the middle is to be used. Since the inner-most wire installation hole has been already used, however, only two wire installation holes can be confirmed for this steps. As a result, the one near to the drive pulley that has been already installed is the wire installation hole [9] at the middle. 9. Insert the drive pulley [10] into the up/down pulley shaft [8] so that the notch [11] of the drive pulley [10] comes to the position into which the up/down wire A [2] is put. 10. Fit the E-ring [12] to fasten the drive pulley [10]. [2] [6] [2] [1] [4] [3] Q5690A [7] [2] [6] [5] [2] [8] [10] [7] [2] [10] [11] [9] [8] [12] 3-20