HP Color 9850mfp Service Manual - Page 431

Q5690A 11. In the same manner as Steps 1 to 5, reinstall the up/down wire A [1] on the rear side. 12. In the same manner as Steps 17 to 21, reinstall the up/down wire A [2] on the rear side. TRAY UP/DOWN [2] [1] III DIS./ASSEMBLY 13. Rotate the up/down drive shaft [1] clockwise as seen from the rear side to lift the up/down plate [2] up to its upper most position. Note: • Be sure to wind up the up/down wire A form inside to outside in each drive pulley. • The up/down plate [2] comes down by its own weight if the installation of the assist wire C [3] and the assist wire D [4] have not been completed. For this reason, be sure to support the up/down plate [2] by hands until the installation of Step 23 is completed. (This work requires two persons.) 14. Insert the assist wire C [3] into the wire installation hole [5] provided outside the up/down drive shaft [1]. Note: • The up/down drive shaft [1] is provided with 3 wire installation holes each on the front side and the rear side. However, since the wire installation holes on the inside and at the middle have been already used, only the wire installation hole on the outside can be confirmed for this steps. 15. Insert the drive pulley [6] into the up/down drive shaft [1] so that the notch [7] of the drive pulley [6] comes to the position into which the assist wire C [3] is put. [3] [4] [9] [17] [16] [17] [2] [4] [14] [15] [8] [9] [7] [7] [3] [1] [5] [6] [10] [3] [1] [4] [13] [18] [12] [11] [1] 3-21