HP Color 9850mfp Service Manual - Page 500

1 OUTLINE Q3224A a. Trim mode When the stopper is released, the pusher plate moves backward to the turnout position to open the booklet ejection path. While the pusher plate is at the turnout position, the trimmed booklet is held stacked upright between the holder plate and the exit tray. Exit tray Pusher plate Stacked booklets When the booklet ejection path is made with backward movement of the pusher plate and release of the press and stopper, the booklet conveyance is re-started again. When the booklet comes out of the vertical conveyance roller, the holder plate moves down and the pusher plate moves forward. Exit tray Pusher plate Stacked booklets Holder plate Stopper Booklet Holder plate When M101(conveyance) turns ON, the stopper is released. When the pusher plate reaches the forward position to hold the booklet between the pusher plate and the exit tray, the holder plate starts moving upward, stopping the upper limit position. b. Through mode When M101 (conveyance) Turns On, the stopper is released. When the booklet is detected in the entrance conveyance section, the pusher plate moves back to the turnout position to open the booklet ejection path. The succeeding operation is the same as in the trim mode. In the through mode, booklet conveyance does not stop temporarily because neither the press operation nor trimming operation is not performed in this mode. 1 - 8