HP EliteDesk 800 G6 Maintenance and Service Guide - Page 46
WLAN module
![]() |
View all HP EliteDesk 800 G6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
6. Reverse the removal procedures to install a new expansion card. Be sure to rotate the slot cover retention latch down into place after installation. 7. After installing an expansion card, connect external cables to the installed card and internal cables to the system board, if needed. 8. Reassemble and reconfigure the computer, if necessary. WLAN module To remove the WLAN module, use these procedures. Table 4-6 WLAN module descriptions Description Intel® Wi-Fi 6 AX201 (2 × 2) and Bluetooth® M.2 Combo Card, non-vPro™ Realtek RTL8822CE Wi-Fi 5 (2 × 2) and Bluetooth M.2 Combo Card Realtek RTL8821CE Wi-Fi 5 (1 × 1) and Bluetooth M.2 Combo Card Before removing the WLAN module, follow these steps: 1. Prepare the computer for disassembly (Preparation for disassembly on page 19). 2. Remove the access panel (Access panel on page 19). 3. Remove the optical drive (Optical drive on page 27). 4. Remove the front bezel (Front bezel on page 20). 5. Rotate the drive cage to the upright position (Drive cage on page 22). Remove the WLAN module: 1. Remove the plastic shield that covers the antennas where they are connected to the module (1). 2. Disconnect the antenna cables from the module (2). NOTE: The WLAN antenna cable labeled 1/MAIN connects to the WLAN module Main terminal. The WLAN antenna cable labeled 2/AUX connects to the WLAN module Aux terminal. 3. Remove the screw (3) that secures the module to the computer. 36 Chapter 4 Removal and replacement procedures
![](/manual_guide/products/hewlettpackard-elitedesk-800-g6-maintenance-service-guide-989a06a/46.png)