HP EliteDesk 800 G6 Maintenance and Service Guide - Page 50
Serial port
View all HP EliteDesk 800 G6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
2. Lift the fan with air duct out of the computer (2). To install the fan with air duct, reverse the removal procedure. Serial port To remove serial port, use these procedures. Before replacing the serial port, follow these steps: 1. Prepare the computer for disassembly (Preparation for disassembly on page 19). 2. Remove the access panel (Access panel on page 19). 3. Depending on model, remove the air duct (Air duct (up to 65 W processor) on page 38 or fan (Fan with air duct (125 W processor) on page 39). To replace the serial port: 1. Disconnect the serial port cable from the system board (1). 2. Remove the two screws from the rear of the computer (2). 3. Pull the serial port into the computer to remove it (3). 40 Chapter 4 Removal and replacement procedures